Hi everyone,
I had some Birdseye Maple left over from a previous project and decided to make a new stand for my wife's photo printer. Took a couple of weekends to knock it out.
Festool's Used:
CT22 and CT26 dust extractors
MFT/3 Tables
TSC55
TXS
C12
PDC
RTS400 - love this little sander
DTS400
Rotex 150
Domino 500
OF1010
HL850 with bench unit
Non-Festool: Hammer A331 Jointer/Planer, Laguna LT18 Bandsaw, Fein 350 Multimaster, Mafell P1CC jigsaw and Bosch JS572 jigsaw, Bessey clamp and DeWalt clamps
Here are some pics of the completed table. Used Domino's for the drawer joints. Solid soft maple drawer bottom. Sanded to 400 grit and finished with a couple of coats of Watco Danish oil - natural. Not worried about water, etc. since it will just have a big printer sitting on top.
I had some Birdseye Maple left over from a previous project and decided to make a new stand for my wife's photo printer. Took a couple of weekends to knock it out.
Festool's Used:
CT22 and CT26 dust extractors
MFT/3 Tables
TSC55
TXS
C12
PDC
RTS400 - love this little sander
DTS400
Rotex 150
Domino 500
OF1010
HL850 with bench unit
Non-Festool: Hammer A331 Jointer/Planer, Laguna LT18 Bandsaw, Fein 350 Multimaster, Mafell P1CC jigsaw and Bosch JS572 jigsaw, Bessey clamp and DeWalt clamps
Here are some pics of the completed table. Used Domino's for the drawer joints. Solid soft maple drawer bottom. Sanded to 400 grit and finished with a couple of coats of Watco Danish oil - natural. Not worried about water, etc. since it will just have a big printer sitting on top.
