Racking to a 2013 transit

paulc75

Member
Joined
Jun 2, 2015
Messages
71
got bored onsite last night and needed an OCD fix [big grin] [big grin]
 

Attachments

  • image.jpg
    image.jpg
    513.7 KB · Views: 1,330
  • image.jpg
    image.jpg
    496.5 KB · Views: 1,249
  • image.jpg
    image.jpg
    478.1 KB · Views: 1,045
  • image.jpg
    image.jpg
    513.7 KB · Views: 1,059
What's that yellow thing is it a new type of transformer or splitter

Nice job by the way
 
Light wand base / splitter. Plug it into the CT then I can plug in kapex and a plug it simultaneously and both will auto start.
 
paulc75 said:
Light wand base / splitter. Plug it into the CT then I can plug in kapex and a plug it simultaneously and both will auto start.

I like the ones that work like a Weeble.
Amble past and knock them and they wobble about a bit then steady.

Heavy things to cart about in a van though which is where the type you have comes in.
 
how high did you raise floor .do you find it hard to get into as the floor is out to edge of van .would you put a step there if you were doing again
 
John,

Floor is raised 300mm from existing bed. It is inset back so I can still utilise the side step and rear step. Best of all it will allow 15 sheets @18mm to stow underneath.
 
paulc75 said:
John,

Floor is raised 300mm from existing bed. It is inset back so I can still utilize the side step and rear step. Best of all it will allow 15 sheets @18mm to stow underneath.

what is the size of your Transit? - roof height? - wheelbase -?
how long have you been using this general set-up?
what would you change if you had to start over?
 
Back
Top