Router Bit - 10*-15* Tapered Table Edge (Round Top 1-1/2" Thick)

[NAS]

Do any of you guys know where I could get a bit to cut say about a 10*-15* taper on the edge of a table top?  I have been looking but most of the chamfer bits I find do not have a long enough cutting edge for a 1-1/2" thick top.  I would just tilt the TS55 can cut away, but it is a round top.

Any ideas?

Thanks.

 

[mouppe]

The Freud 99-516 router bit has a 17 degree bevel which I use on the undersides of table tops.

 

[sancho57]

http://www.woodline.com/p-1447-chamfer-bits.aspx

 

[Sparktrician]

The Amana 54117 has a 15° cut angle. 

 

[Wonderwino]

Several years ago, Roger Savatteri had a huge custom bit made to run in his OF2200.  It is a deep curved profile and the bit will literally fill a coffe mug.

http://festoolownersgroup.com/index.php?action=dlattach;topic=7706.0;attach=16815;image

[eek]

 

[jhillman]

Here is a link to a company that makes end mills for machinests:

http://www.conicalendmills.com/

Just put in their search 'Tapered end mills"