Sysport Drawer Shelf Template Or Dimension

[JZ Bowmannz]

Hello Everyone,

I remember seeing a drawing here for the location and relative dimension of systainer's shelf (4 cut out for systainer to sit in) in the past, but I've been seaching for a while and just could not find anything.

The shelf as seen below from member Scorpion.

View attachment 1

Would anyone have one that I can use, please?

Thanks. JZ

 

[nclemmons]

[member=27782]Scorpion[/member]  - do you have the dimensions by chance?

 

[Vondawg]

Garry Martin had a nice measured out template for shelves.....can't find the post

 

[Z48LT1]

Here's one answer: Reply #5 athttp://festoolownersgroup.com/workshops-and-mobile-vehicle-based-shops/two-deep-systainer-drawers/

Best - Gary

 

[JZ Bowmannz]

Here's one answer: Reply #5 athttp://festoolownersgroup.com/workshops-and-mobile-vehicle-based-shops/two-deep-systainer-drawers/

Best - Gary

Never thought about cutting them separate and rejoin them together, smart!

I will follow Richard's and Billy's lead and give a try.

Thank you everyone！

JZ

 

[GarryMartin]

Here's mine...

I used a different approach - 17mm bush with 10mm cutter and a template. Knocked them out in no time at all. Used in conjunction with the SYS-AZ drawers for less frequently accessed items.

 

[JZ Bowmannz]

[member=1943]Garry[/member], your template validated my measurement.

I had 280mm between two feet cross and 167mm front to back. Taking out 7mm bushing off set, so they are at 273mm and 160mm. The front feet are 45mm x 38mm, so your cut out is 52mm x 45mm, and they are the Datum, the rear can run wild since they are smaller... Good simple engineering!

Thank you!
JZ