Table Saw Outfeed

[w802h]

It's not a Festool, but here is my outfeed set-up for my jobsite tablesaw.  2 screws attach the 14" wide hollow core door at each end and 2 screws set the height of the distal leg.  The beauty of the system is that there isn't a lot of fiddling to level the system since the outfeed follows the plane of the saw.  In fact, I can intentionally tip the saw slightly toward the fence to help get a consistent cut in floppy materials like Koma, my "favorite" of the plastic boards.  I do all my cutting over lumber wraps that make pick-up fast at the end of the day. 

 

[NYC Tiny Shop]

Good idea. Thanks for posting.

 

[Northern Early]

Very nice. I have been building my on site collapse able benches to match the height of my 4100 ( I think that's it). I wish my miter sat at the same height on its yellow stand to make everything equal but an out feed is a godsend in the field alone.