Tormek Storage Trays

[ferrij]

Anyone know if the Tormek storage trays fit inside festool systainers?

JF

 

[Bob D.]

Don't know but looking online at the Tormek site I see the TC-800 case
overall dimensions are 16" (405mm) x 12 1/8" (308mm) x 3 1/2" (90mm).
That's for the case so the tray should be slightly smaller all around.

That sounds close to a T-Loc Sys I size (400x300x90).

Maybe you could trim it down to fit in a Systainer.

 

[Paul_HKI]

They don't fit. 

 

[ferrij]

Thanks Tom. I thought about trimming but there is very little extra on the edges. I think I'll go with kaiser foam instead.

JF

 

[ferrij]

Sorry, I meant Paul!

 

[blues]

They don't fit. You would have to trim off some from the edge,  and if you do you should be aware that once you take them out the are not usable. 

 

[wwb119]

ferrij -
Did you end up trimming down the Tormek tray ?
I am considering getting a Sys-Combi 3 (with drawer) for the Tormek parts, and was wondering how yours worked out.
thanks,  Rich M.

 

[ferrij]

Just ordered them this week after obsessing about it. My plan is to make custom drawers for them. I don't think they will fit in a systainer and I would prefer to make a couple of drawers than trim to fit in a systainer. When they arrive I let you know if trimming is feasible. JF

 

[wwb119]

ok, sounds good, thanks !