TS75 WITH MFT3

[Wood Hog]

Quick question, does the TS 75 work well with MFT 3?  Or is it too big!
Cheers

 

[ear3]

Works just fine.  The only issue I could potentially see is if you are doing cross cuts on a panel the full depth of the table.  At that point you probably wouldn't have enough overhang at the front of the standard rail to accommodate the 75, which requires more lead in space than the 55.  But you could always swap out another rail in that situation.

 

[dltflt]

No problems.

 

[bigjonh]

I found the 75 cumbersome on the mft. I wish I'd have held on to my ATF55, which served me well for many years to leave dedicated on the mft, but I sold it in order to get the ts55req. Which got recalled so I swapped it for the 75, which was a good deal. But I didn't like using the 75 on the mft. So I picked up a used 55 which stays on the mft most the time, while the 75 stays mostly in the truck for field use. Just my opinion though, technically it works just fine.

 

[Wood Hog]

Thanks for the quick reply. I'm down at the festool saw and put the 75 on the MFT3  it seems as though it might work.
Cheers

 

[croessler]

I have been using the ts75 on the mft3 for a few years now; it works just fine but can be a little cumbersome. As a fairly large fellow it does not present an issue for me normally. I went with the 75 because I often breakdown 8/4 and 12/4 stock.

 

[Wood Hog]

I bought the MFT 3,love it, still trying to square the fence thanks for all your input, you guys rock.

 

[Birdhunter]

Are you using Qwas dogs to square the fence?

 

[sumantamandal]

No problems at all.
I'm a short guy

Cheers!
Sumanta