UG stand or Kapex MFT?

[Woodchippie]

Interested to know which stand you use? I Would prefer both, but would have to settle for one of them.

 

[semenza]

Interested to know which stand you use? I Would prefer both, but would have to settle for one of them.

I  it depend on your use.

I have the table set up. Most places I go I would need to carry the saw at least part of the distance anyway. Plus if the saw is on the UG stand it will not fit under the tonneau on my truck. I also find the small MFT is handy as a small bench when I don't need the saw.

Seth

 

[copcarcollector]

Are you taking the saw to a jobsite? I have found the Kapex on the UG stand remarkably lightweight to take in and out of my SUV. Right now I have it set up at work with one extension wing. The whole thing is a little wobbly but nothing that bothers me too much, I have the MFT as well and found it more stable. I like that there is a little room on the MFT table to put a pencil or a square or a tape measure.

 

[Woodchippie]

Interested to know which stand you use? I Would prefer both, but would have to settle for one of them.

I  it depend on your use.

I have the table set up. Most places I go I would need to carry the saw at least part of the distance anyway. Plus if the saw is on the UG stand it will not fit under the tonneau on my truck. I also find the small MFT is handy as a small bench when I don't need the saw.

Seth

Yes, thanks Seth. I will be using it mobile mainly. I did consider the multi use of the MFT. One reason I finally bought the  Kapex was the light weight.

 

[Woodchippie]

Are you taking the saw to a jobsite? I have found the Kapex on the UG stand remarkably lightweight to take in and out of my SUV. Right now I have it set up at work with one extension wing. The whole thing is a little wobbly but nothing that bothers me too much, I have the MFT as well and found it more stable. I like that there is a little room on the MFT table to put a pencil or a square or a tape measure.

Do you use the wings with the Kapex MFT? I would like to purchase the crown stops, but I'm under the impression the wings don't fit when the crown stops are attached.

 

[semenza]

Are you taking the saw to a jobsite? I have found the Kapex on the UG stand remarkably lightweight to take in and out of my SUV. Right now I have it set up at work with one extension wing. The whole thing is a little wobbly but nothing that bothers me too much, I have the MFT as well and found it more stable. I like that there is a little room on the MFT table to put a pencil or a square or a tape measure.

Do you use the wings with the Kapex MFT? I would like to purchase the crown stops, but I'm under the impression the wings don't fit when the crown stops are attached.

    This is true, they don't work at the same time. There are some after market brackets that allow the use of the stop sans short crown extensions  with the long UG  extensions.

Seth

 

[semenza]

Are you taking the saw to a jobsite? I have found the Kapex on the UG stand remarkably lightweight to take in and out of my SUV. Right now I have it set up at work with one extension wing. The whole thing is a little wobbly but nothing that bothers me too much, I have the MFT as well and found it more stable. I like that there is a little room on the MFT table to put a pencil or a square or a tape measure.

Yup, that too.

Seth