Veritas Hold-Down

[FesRookie]

Hello,  I'm new to this Group, but happily own the Festool Domino and Track saw...great tools!  I'm going to build an outfeed table/assembly table with 20mm holes using the Parf system.  I have 3/4 inch holes on my workbench and use, and like the Veritas Screw Hold Downs, which spec a 3/4 hole.  I imagine some of the folks here may have tried these on their MFT, and wondered if someone coudl tell me if they worked?  Thanks!

 

[Peter_C]

The Veratis won't work with a 20mm hole.

There are lots of options though. Festool has their own clamps with Clamping Elements being nice to have, along with their quick clamps. Kreg clamps work great too. I have the long version with Precision plates. They MUST be screwed down or they will mess up the holes.

 

[Rick Herrick]

If you do have the Kreg clamps, these guys could be helpful.
https://precisiondogs.us/collections/frontpage/products/precision-clamp-mount

 

[Stan Tillinghast]

That’s the combo I use, and they work great. I have 2 long Kreg clamps and one short one.
Clamping elements are great if you need to have the whole surface available as with sanding; otherwise the Kregs are very solid for cutting, drilling, routing, etc.

 

[infer]

BESSEY Auto-Adjust Toggle Clamp works great.

Bessey code STC-HH50-T20

 

[modeller]

I have the lee valley table clamp plates and they work great with my Automaxx Kreg clamps!
https://www.leevalley.com/en-ca/sho...post-and-clamp-knob-for-kreg-hold-down-clamps