1400 EQ router for MDF

[Kwolsen]

I'm trimming out some interior windows with MDF.  The MDF from HD has the rounded over edges. I need to rip the length of several pieces using my TS55 and track but I'd like to use a round over bit to add the rounded profile back.  Would using a 1400 router on the track be a good idea or is getting a router table preferred? Small workspace is always my driving issue so the router table may be too large, and those bench top ones look marginal.

Also, is the MIDI dust extractor sufficient for this application or would you spend more for the CT26E ?

Thanks

 

[Owego]

I'd use a round-over bit with a guide bearing.  I don't remember seeing pre-cut MDF casing at HD.  Your post used the word "trim" did you mean casing - i.e. the trim that bridges from the jambs to the wall ?

 

[Kwolsen]

Yes, I meant the casing that lays flat on the wall. The inside jamb is covered with primed FJ pine.

 

[Rudymejia12]

I would say table saw and small trim router. And I have the midi with Oneida on top. Works great!!

 

[rst]

I'm with Rudy in regards to the Oneida sitting on top of a Midi.  I use mine as stationary unit at my cutting table, empty about twice a year.  The only drawback is that the Oneida is not made to fasten to the Midi.  I had to trim the flanges on the Oneida and ran a rachet strap around the whole unit.  I've been using this setup for about six years now.

 

[RKA]

The midi will work fine, however, if the DE will stay in the shop and mobility isn't a concern, I would recommend the 26.  The midi/mini have a sharp 90 degree connector at the end of the hose where it attaches to the DE.  Inside the unit there is another sharp 90 degree elbow that sits inside the bag.  My experience has been that it cuts down on airflow.  Not an issue for many tools, but routers, planers and saws want as much airflow as you can throw at them.  You buy a 36mm hose for the saws (which will also eliminate one 90 degree turn), but for handheld routing it's a bit hard to manage the larger hose.  And with the 36mm hose attached, you cannot have anything sitting on top of the midi (like the oneida) because the hose exits straight up.

Note:  Festool has released a tapered hose (32-27mm) in recent years which is included with the midi.  I don't have this, so my comments above don't take that into account.  That should help a bit with airflow, but the 2 90 degree turns remain. 

 

[Rudymejia12]

I'm with Rudy in regards to the Oneida sitting on top of a Midi.  I use mine as stationary unit at my cutting table, empty about twice a year.  The only drawback is that the Oneida is not made to fasten to the Midi.  I had to trim the flanges on the Oneida and ran a rachet strap around the whole unit.  I've been using this setup for about six years now.

What strap do you use. I have read a lot of people doing that. I just got my Oneida and thought the cutting flanges was enough. Maybe not

 

[rst]

I just a cheap hardware store strap, probably came in a multiple pack.  The strap is not on yet in pic.