20 mm drawer pull fits MFT.

[docterry]

I ordered several of these 20mm cylindrical drawer pulls from build.com for a few bucks each. They are a friction fit in my MFT/3 and my MFT 1080. They don't seem sturdy enough to clamp against, put they are perfect for locating a jig on the mft top.

Liberty Hardware PN2814C-C Whistle 13/16 Inch Diameter Cylindrical Cabinet Knob

 

[Dick Mahany]

Thanks for posting that info !  I just made an MFT cart that has a removable / replicated MFT surface below the folded MFT.  I need a simple way to register that auxilliary top to the cart to prevent it from sliding around.  I think a couple of these will do the trick nicely.

[attachimg=1]

 

[kitui]

I bought 6 of them but they are not straight. They fit quite snuggly but would not keep to holes aligned on top of each other. I love the way they fit snuggly but they are not cut straight.

 

[Gregor]

I need a simple way to register that auxilliary top to the cart to prevent it from sliding around.

Some screws would do that trick, in case you are unsettled about cutting into them accidently you could also use some dominos (or simple dovels) to align it to the cart.