3D Printed Aftermarket ETS EC 150 Edge Sanding Guide?

[smorgasbord]

Anyone try this thing, available from Etsy:https://www.etsy.com/listing/1633313589/festool-ets-ec-150-kit?variation0=4147224941

[attachimg=1]

I know Festool makes one for the ETS EC 125, but I've got only the large 150mm model.

 

[Packard]

Peter Millard made his own. 

 

[guybo]

Hi, these have been out a awhile.either@90 or 45 degrees

 

[GarryMartin]

Have printed this one this week but haven't tried it yet...
https://www.thingiverse.com/thing:6209148

 

[smorgasbord]

So, I did order the one I linked in the first post. I'll report back when I've tried it out.

 

[smorgasbord]

It arrived yesterday. Seems decent, but a couple niggles:
1) Since it's 3D printed, the reference surface that goes against the stock face isn't smooth and will scratch soft materials. I sanded it down and attached some HDPE tape to the face.

2) I got the stand that enables the sander to be used as a stationary disk sander. But, the attachment doesn't lock into the stand and can easily rotate (which is how you remove/install it). I could probably drill a hole for a grub screw to lock it in place, but it's a bummer.

That all said, it attaches pretty easily to the sander, seems secure, and work to hold the sander for edge and similar sanding.
[attachimg=1]

[attachimg=2]

[attachimg=3]

[attachimg=4]