accurately cutting 3" stock with a TS-75

[kiarev]

Hello,

I have a cutting table set up with a Parf Guide System and I use Festool guide rails and a TS-75 saw.  How do I accurately cut 3" laminated stock on that system??  I know I can rotate the stock around 180 degrees, but I am afraid that will severely detract from my accuracy.  Any suggestions would be appreciated.

Mark Hagy

 

[sancho57]

what I did was cut the stock rotate 180 then ran it through my jointer.

 

[Svar]

Take TS75 off the rail and use the rail as straight edge instead. It might cut through.