Greetings,
I would like to buy a long piece of alluminum extrusion for a cross cut table I'm building.
it needs to be 19mm in thickness (just under 3/4") or a little less is fine. The width should be at least 2.5" to 3" minimum.
ideally it would accept the flipstops that come with mft fences and kapex extension wings, etc....
any ideas on which model and where to get it??
Thanks so much for your time.
Brice Madden
I would like to buy a long piece of alluminum extrusion for a cross cut table I'm building.
it needs to be 19mm in thickness (just under 3/4") or a little less is fine. The width should be at least 2.5" to 3" minimum.
ideally it would accept the flipstops that come with mft fences and kapex extension wings, etc....
any ideas on which model and where to get it??
Thanks so much for your time.
Brice Madden