The article ( www.festoolusa.com/Web_files/Domino_WCM_zigzag.pdf ) that I published on my zigzag dining chair, which was described in this thread:http://festoolownersgroup.com/index.php?topic=803.0 , did not cover the building of a matching carver. I describe building the carver in the article that I have attached below in two parts. Measurements in the article are given in millimeters. The article describes building the chair by routing its mortises using a precision mortising jig. But the chair could easily be built using a Domino instead.
Rocker
Rocker
