Angled Edge Band Trimming, How?

[copcarcollector]

So this question is just based on a Conturo video I watched. This guy applied edge banding to an angled edge, not 90 degrees. Just curious how you trim the edges in this situation, as the MFK and trim routers I see only work at a 90 degree angle.

[attachimg=1]

 

[rvieceli]

I believe you would use the router with the horizontal base. that puts the bit parallel with the top surface.

 

[tjbnwi]

The MFK 700 will trim that. You can also use a file.

Tom

 

[flair woodworks]

You can use the MFK 700 EQ/B with the planing bit to trim beveled edges like that.

 

[Crazyraceguy]

The MFK700 will do that just fine. It would depend on how much angle you had to deal with and your "follower bearing" adjustment would be different one opposite sides. If the angle was too severe, you may not be able to reach out that far with the router horizontal, but it would work vertically with the planing bit.