Another router and table?

[hobbes]

Anyone consider an OF 2000 table-mounted? How well does that work?

I was looking at this thread and seems that there may be some around for $344. What do you think? Is that the way to go or perhaps the Milwaukee 3 1/2 HP?

Some of you guys just listed your router and table combo but didn't explain why you went that way? Price? Certain features? or ??

 

[Rembo]

Anyone consider an OF 2000 table-mounted? How well does that work?

I was looking at this thread and seems that there may be some around for $344. What do you think? Is that the way to go or perhaps the Milwaukee 3 1/2 HP?

Some of you guys just listed your router and table combo but didn't explain why you went that way? Price? Certain features? or ??

What is a router table? it's just the engine! All gadgets are not needed here! cope with this lift. INCRA stress can be tuned instantly!
but I think when you try to INCRA, you understand me ..

 

[tiralie]

Anyone consider an OF 2000 table-mounted?

Not really, well if the CMS was available in NA I would think about it but I am not sure that is the best use of a festool router.

I was looking at this thread and seems that there may be some around for $344. What do you think? Is that the way to go or perhaps the Milwaukee 3 1/2 HP?
Some of you guys just listed your router and table combo but didn't explain why you went that way? Price? Certain features? or ??

It depends. If you are planning to take your router out of the table regularly and use it "on site" it might be a good solution.
For me I didn't/don't want to take my router out of the table every time I need a work-site router so buying the Milwaukee was a better decision.
I also liked the Jessem setup because the dust collection is very good. I have two hoses connected to a Vacuum via the the Y connector and it collects 95% of the dust and chips created by the router.
My original intent was to buy a shaper but I couldn't accommodate one (power and space) so I looked for the next best compromise.

 

[Rembo]

Anyone consider an OF 2000 table-mounted?
Not really, well if the CMS was available in NA I would think about it but I am not sure that is the best use of a festool router.

I was looking at this thread and seems that there may be some around for $344. What do you think? Is that the way to go or perhaps the Milwaukee 3 1/2 HP?
Some of you guys just listed your router and table combo but didn't explain why you went that way? Price? Certain features? or ??

It depends. If you are planning to take your router out of the table regularly and use it "on site" it might be a good solution.
For me I didn't/don't want to take my router out of the table every time I need a work-site router so buying the Milwaukee was a better decision.
I also liked the Jessem setup because the dust collection is very good. I have two hoses connected to a Vacuum via the the Y connector and it collects 95% of the dust and chips created by the router.
My original intent was to buy a shaper but I couldn't accommodate one (power and space) so I looked for the next best compromise.

to his desk is made ​​dust extraction