Battery with a light beep while charging

Jim_in_PA

Member
Joined
Nov 23, 2017
Messages
486
I have two of the 4.0AH batteries that came with my CXS 18. One of them, when in the charger, has a repeating light beep sound every 10 seconds. The other does not. Both are on the most current firmware. Any thoughts about the beeping on that one battery and is it something to be concerned about? Thanks in advance!
 
The 4.0 battery packs are problematic, there's been a lot of discussion and comments on the FOG about the problems associated with them. Personally, I think there should be a recall to rectify the situation. I have 3 of the batteries, the newest with 8 charging cycles will charge to 100%, the one with 18 charging cycles will only charge to 66% and the one with 56 charging cycles will only charge to 71%. I like the performance considering their size and weight but Festool should address the problems associated with them.

If your batteries are still under warranty, I'd keep a sharp eye on them to make sure the "light beep sound" doesn't turn into a larger issue.
 
Last edited:
What kind of beep? Usually the charger pauses every few x seconds to check what the no-load voltage is. This might cause coilwhine.

Are they the 4.0 HPC with 21700 cells?
 
What kind of beep? Usually the charger pauses every few x seconds to check what the no-load voltage is. This might cause coilwhine.

Are they the 4.0 HPC with 21700 cells?
They are the standard 4.0 AH batteries that came with my CXS 18. It's a single beep every ten seconds while on the charger.
 
Just chargers. TCL 6 Duo is a two slot version of the TCL 6 that comes with lots of tool kits. SCA 8 is the rapid, air cooled charger. I ask because the TCL 6 is notorious for making noises which sound like beeping.
 
Thanks. I only have the charger that came with the drill/driver and batteries. I'll check the model number when I go out to the shop later.

Edit...single slot TCL 6
 
Last edited:
Back
Top