CMS-VL MFT/3 setup for a 3 1/2 in. cutter diam

[robcamp]

The router table fence is to narrow to handle a raised panel bit with a cutter diam of 3 1/2 inches.  Is there a different setup or adjustment I can make to work with this bit?

 

[geoffshep]

If you mean that the fence will not open up wide enough, have a look at this which should start at the 8m44s point:
=8m44s

 

[robcamp]

The fence is just about 1/8 inch to narrow.

 

[GarryMartin]

If you mean the shroud, then you can either file it away, or for the simplest solution, just add a secondary fence.

Seehttp://festoolownersgroup.com/festo...maximum-bit-diameter-cms-with-of-2200-router/