Copper and White Oak Veneer Bar

[Kevin Johnson]

Here are some pictures of a bar that I made.  The top is an inlay of copper and white oak over a MDF substrate.  Its design was inspired by the beautiful work that Per does (thanks! ).  I used the TS 55 to cut all the panel and the veneer for the inlays.  I used the 1400 router to square off the inlays as well as route the substrate for the wood inlays.  I had to route them out because the copper was thinner than the wood veneer.  All sanding was done with Festool sanders.

[attachthumb=#]
[attachthumb=#]
[attachthumb=#]

 

[Kevin Johnson]

More pictures...
[attachthumb=#1]
[attachthumb=#2]
[attachthumb=#3]
[attachthumb=#4]
[attachthumb=#5]

 

[ambob]

nice!i want topost it to china woodwork fourm,ok?

 

[Kevin Johnson]

Thanks, sure go ahead and post it.

 

[robtonya]

That is nice. I want to have a drink! I like the use of the copper, and that Per inspired you. I have a friend that has wanted me to help him build a bar, he has been talking about it for almost a year now, but I recently seen Per's work, I was going to show him how good looking it could be if I had some skills.  ;D