I wanted to build such a cross cutting sledge with my new CMS table saw module. However, there is no real guide slot within the table like most standard table saws have.
I tried to achieve with wooden rails on the side mounting (see attached photo). It seems to have enough precision.
With the 5 cuts method for square calibration I get many different results therefore I am circle around the final result.
[attachthumb=1]
[attachthumb=2]
What would you suggest?
Andreas
I tried to achieve with wooden rails on the side mounting (see attached photo). It seems to have enough precision.
With the 5 cuts method for square calibration I get many different results therefore I am circle around the final result.
[attachthumb=1]
[attachthumb=2]
What would you suggest?
Andreas