CS 70 rip fence

[Kris1980]

Hi,

I've been using the CS 70 with the rip fence for rough ripping stock. However, since a few weeks, I've noticed whenever I tighten the fence using the big knob, it seems to pull the fence slightly out of square (about 2-3mm over the whole table length). Has anyone encountered this as well? If so, any ideas on how to straighten it out? I don't feel like sending my table saw back to Festool just for that...

Regards, Kris

 

[sancho57]

i have the CS 50 rip fence.

Im assuming they are pretty much designed the same.

Under the head of the fence you will see 4 allen head bolts. Those are used to adjust the fence.

Just got to play with them.

Hope this helps