I searched for a previous post on this subject, but couldn't find one....
Recently my CT48 extractor shuts off during use. It occurs in the manual on/off mode, but it's possible that it also does it when using the extractor in the auto on/off mode with a tool plugged in. After I turn the switch off, then back on, it runs again. Sometimes it will shut of a second time, but mostly it just works as it's supposed to. I noticed it once or twice some time ago, but now it's more frequent.
It's not a plug or power cord thing because it will turn back on without unplugging/plugging back in.
Has anyone else experienced this? My CT48 is more than 5 years old and is used completely indoors in my shop. I have not checked the filter bag to determine if it's full, but the last time it was full, it didn't act this way and, if it's due to a full bag, I would assume it would not turn back on again.
Recently my CT48 extractor shuts off during use. It occurs in the manual on/off mode, but it's possible that it also does it when using the extractor in the auto on/off mode with a tool plugged in. After I turn the switch off, then back on, it runs again. Sometimes it will shut of a second time, but mostly it just works as it's supposed to. I noticed it once or twice some time ago, but now it's more frequent.
It's not a plug or power cord thing because it will turn back on without unplugging/plugging back in.
Has anyone else experienced this? My CT48 is more than 5 years old and is used completely indoors in my shop. I have not checked the filter bag to determine if it's full, but the last time it was full, it didn't act this way and, if it's due to a full bag, I would assume it would not turn back on again.
