DeWalt GA

[WarnerConstCo.]

I bought this Dewalt GA at a cabinet shop liquidation, it originally came from Goodyear in Jackson, MI.

It's 3hp 3ph, 14" blade, I think 20 inches of crosscut at 1" thick.

It was nasty green, needed bearings, came with junk blades, worn out table and a starter with no cover.:laughing:

I think I got it close enough for me now.

There are things I would still like to finish on it, but it probably won't ever happen.

I will make some cuts tomorrow.  Made a two position fence, high and low fence.

 

[jbasen]

Very nice restoration!

 

[dltflt]

Looks like new.

 

[woodguy7]

Hey Darcy, i admire your passion but have a question.  Do you collect these machines & restore as a hobby or is it actually your job ?  I mean do you sell them on for a profit.  If you keep them all then you must have one hell of a big workshop & impressive setup.

Cheers.

 

[WarnerConstCo.]

Hey Darcy, i admire your passion but have a question.  Do you collect these machines & restore as a hobby or is it actually your job ?  I mean do you sell them on for a profit.  If you keep them all then you must have one heck of a big workshop & impressive setup.

Cheers.

I do architectural millwork mostly. 

I do like machines and have upgraded quite a few, a few times.

I do buy some stuff to sell, I have been using that to work on my house.