DIY cabinet under MFT/3, missing dimensions

[tgynther]

I’m building a DIY cabinet to go under an Festool MFT/3 table that I plan to buy later. Could someone share the exact outside-to-outside measurements (in millimeters please ) between the corner brackets, so I can cut the tabletop to the correct size?

 

[tjbnwi]

Are you sure you want between the brackets. Most are built so the leg brackets sit on the bench.

Tom

 

[tgynther]

Are you sure you want between the brackets. Most are built so the leg brackets sit on the bench.

Tom

You're right. Leg brackets must sit on the bench

 

[tjbnwi]

772x1153, the rubber feet set in about 10mm.

Tom

 

[tgynther]

Thanks!

 

[mac sparrow]

Just Google the size of an MFT/3.


Took 10 seconds!

I would make the cabinet the MFT/3 will sit on slightly larger.

 

[tgynther]

Just Google the size of an MFT/3.
View attachment 380851

Took 10 seconds!

I would make the cabinet the MFT/3 will sit on slightly larger.

Even when I work with analogue wood I can also use computer to google

As you can see from Tom's answer actual dimension from leg brackets are less than surface dimension. If you make cabinet larger than surface it could interfere with aluminium profile attachments. So I would say that cabinet should be slightly smaller than surface.

 

[onocoffee]

My friend just finished his MFT undercabinets last week.