I'm a Visual Learner and think in inches and fractions
of inches - not in decimal inches. So when I try to
visualize where a mortise would be using the built
in retractable "stop pins" I get a headache - 37mm
to mortise centerline, back up 1/2 of 13mm then
add 1/2 the bit diameter - arghhhhh!
So I've done some Visual Aids to make my life
a little easier when playing with the DOMINO.
Print them up on mylar or anything translucent,
folk over the ege where the pin would register
and lay one on my part to see which "preset"
options works for my immediate need.
http://web.hypersurf.com/~charlie2/DOMINO/DOMINOmortiseVisualAids.html
Two GIF files you can download, print to whatever,
cut out and put on your part to see what will
fall where.
charlie b
as always, constructive critique welcomed
of inches - not in decimal inches. So when I try to
visualize where a mortise would be using the built
in retractable "stop pins" I get a headache - 37mm
to mortise centerline, back up 1/2 of 13mm then
add 1/2 the bit diameter - arghhhhh!
So I've done some Visual Aids to make my life
a little easier when playing with the DOMINO.
Print them up on mylar or anything translucent,
folk over the ege where the pin would register
and lay one on my part to see which "preset"
options works for my immediate need.
http://web.hypersurf.com/~charlie2/DOMINO/DOMINOmortiseVisualAids.html
Two GIF files you can download, print to whatever,
cut out and put on your part to see what will
fall where.
charlie b
as always, constructive critique welcomed
