I have a problem with my Domino and that is that the slots get tilted.
If I make a wide 5 mm slot and measure in the ends it is tilted about 0,15 mm.
It does not make any difference if I index off the base or off the fence.
My second Domino makes exactly the same error.
Is this within the tolerances?
Any suggestions?
If I make a wide 5 mm slot and measure in the ends it is tilted about 0,15 mm.
It does not make any difference if I index off the base or off the fence.
My second Domino makes exactly the same error.
Is this within the tolerances?
Any suggestions?
