Drawer pull cutter

[ldmillar1981]

Hi all,
Just wonder if anyone has any experience using either This or similar cutter, or if anyone has any recommendations?

I am planning on making my own kitchen out of 18mm birch ply, with those handles routed in to the doors and drawers, will probably do them out of solid oak, beech or ash, and rout a tongue on the handle piece and a groove into the door.

Any advice on the cutter would be gratefully received, not sure if that is even the right one for 18mm material has dim X as 19mm.

I have made a handleless kitchen before with a 45angle on the top but those kitchens are a faff!

Regards
Leigh

 

[cliffp]

I bought the Axminster no 2 to use on oak. The oak was attached to some veneered mdf and was around 19.5mm thick. The cutter worked beautifully. The photos below show the result.

[attachimg=1]
[attachimg=2]

 

[ldmillar1981]

Thanks cliff looks good