Edge Banding for the Conturo

[Jason.L.Hagen]

Hello all,

I just got the Festool Conturo and now I need to find a place that I can buy some edge banding. I’m looking for some maple edge banding as Im using 3/4 maple plywood. Everything I’m finding already has the glue on it. So that defeats the purpose of the Conturo. Any suggestions on where to purchase it?

Sent from my iPhone using Tapatalk

 

[tjbnwi]

Assuming you're in the US;
https://www.framatech.com

Tom

 

[Jason.L.Hagen]

Assuming you're in the US;
https://www.framatech.com

Tom

Yes, I’m in the US. Washington State.

Sent from my iPhone using Tapatalk

 

[cbyrd]

I have purchased from these people.    Great Service and good product.
TapeEase

 

[Tom the Remodeler]

This is my local (Minneapolis/St. Paul, Minnesota) supplier for non-glued, fleece-backed veneer edge banding. I believe they ship….
https://www.holdahlcompany.com/

 

[Jason.L.Hagen]

Thanks all! I will check out those places! Does anyone know if someone might sell the glue pucks in smaller quantities? 48 seems like a lot! But then again, I don't know how far one goes. Does anyone know how many feet, roughly, you get out of one?

 

[afish]

It varies depending on how much glue you apply.  I dont really pay attention I just fill it when it beeps at me.  I will say it uses more than expected. 

 

[squall_line]

Does anyone know how many feet, roughly, you get out of one?

This is highly dependent on so many things.  Setting on the unit, width of banding, etc.

One old post on here that I ran across said approximately 8 meters (26 1/2-ish feet) on 3/4" banding.

YMMV considerably.