Hello,
While sanding on a piece this morning my ETS 150/3 started acting up. It began where it would sand at full power for a few seconds and then bog down to the point it sounds like it is going to stall. Now it is to the point where very little pressure causes it to act up. Literally the sander's own weight will cause it to bog down. As soon as you pick the sander up off the piece, the power will pick back up but go right back down when you set it down.
Before I shipped it off for out-of-warranty repair (warranty went out 5 months ago), has anyone ever experienced this?
Thanks.
While sanding on a piece this morning my ETS 150/3 started acting up. It began where it would sand at full power for a few seconds and then bog down to the point it sounds like it is going to stall. Now it is to the point where very little pressure causes it to act up. Literally the sander's own weight will cause it to bog down. As soon as you pick the sander up off the piece, the power will pick back up but go right back down when you set it down.
Before I shipped it off for out-of-warranty repair (warranty went out 5 months ago), has anyone ever experienced this?
Thanks.