derekcohen
Member
- Joined
- Jun 22, 2008
- Messages
- 956
This was to be a box for two marking gauges, but I managed to squeeze in another tool ... which is great since I was not sure if there was going to be space enough in the tool box for it.
A little packed ... as a puzzle box should be
First out is this wheel cutting gauge. It uses a Veritas micro adjuster. This is my favourite marking gauge as it has a broad head/fence for excellent registration ...
Then out comes this combination mortise gauge and cutting gauge. This is the mortise gauge side. It uses fixed cutters in 3mm, 6mm, and 8mm ...
Reverse the arm and it becomes another cutting gauge ... we always need two on hand ...
And, lastly, a small router plane. This is built around the Veritas blades. 6mm and 12mm stored in the box ...
There is a fence, which extends its use for grooves and rebates ...
And that's all folks.
Regards from Perth
Derek
Last edited:
