Crazyraceguy said:I would indeed. I use mine a lot with the Shaper Origin. It has to be plugged in, which is "on" since the computer and camera part are not "switched". If you plugged it into the CT it would run constantly. There is no way to make the "spindle" activate the vac itself.
Krzysztof Boksa said:Saw this thread and I felt like.ai need to step in.
I was also into sniffing Festool BT protocol. When I saw thread I though that someone actually cracked pairing, but now I see it works on Advertisment.
So for remote it should be ok. Batteries will be a problem, as those are advertising only for a while, and stop the proces if no receiver in pairing is found after a while. The only way to make batteries work is, first to pair and then react to commends.
So yes, for remote it might work ok,
For batteries it won't
And of course they had to make our life and use security BLE transmission. I think without descent sniffer and massive knowledge about BLE, remote is the best we can get. I gave up after a while and just used festools receiver. Is not much more expensive that remote solo.
But good work any way. Good job.
Krzysztof Boksa said:Saw this thread and I felt like.ai need to step in.
I was also into sniffing Festool BT protocol. When I saw thread I though that someone actually cracked pairing, but now I see it works on Advertisment.
So for remote it should be ok. Batteries will be a problem, as those are advertising only for a while, and stop the proces if no receiver in pairing is found after a while. The only way to make batteries work is, first to pair and then react to commends.
So yes, for remote it might work ok,
For batteries it won't
And of course they had to make our life and use security BLE transmission. I think without descent sniffer and massive knowledge about BLE, remote is the best we can get. I gave up after a while and just used festools receiver. Is not much more expensive that remote solo.
But good work any way. Good job.