Festool MW1000 Extension Table

[cortes]

I got the MW1000 Extension Table to attach to my MFT3 to support long stock while sawing. I kept it up for a project I was working on to hold some of the panels. I ended up doing the glue of the unit on it because the narrow width let me clamp to the bottom on both sides of the piece. This is the glue up:

[attachimg=1]

I'm posting this to show how much weight it can hold. I'm guessing that's at least a hundred pounds on it. The bench was wobbly so it probably could take more.

 

[sancho57]

Wow nice thanks for the info

 

[nclemmons]

You have close to 100 pounds in clamps!  Nice use of the side table.

 

[Jim_in_PA]

That was a good idea for sure. I hadn't thought about these extensions in the past, but I may just pick one up.