Gecko-MFS adapter

[sigve]

Dear Festool,

I'd very much like see a MFS adapter for the Gecko.  With the Guide Rail Adapter attached, the Gecko sits nicely next to the MFS, with the GRA not protruding above the top of the rail. The MFS adapter could be a separate fixing for the Gecko, or simply a bracket that slides into the side of the MFS, and connects to the existing GRA. Please make sure that the Gecko's main body sits far enough from the MFS to allow free movement for all routers.

Best,
Sigve

 

[boisetmetal]

If you go to Gecko, (I have 1) I think this system work better when you have Two set !

I have to cut long laminate panel, and with only one, it's moving a little bit !

 

[rst]

I cut mostly plastics and use two Geckos which I store vertically in a Syst II.