Guido Henn sanding

a great video as usuall from guido.
its a shame they arnt in english , or even american.
its good timing. i just bought 2 of those drums for sanding . i am planing a table something like that.
i think i would put a few holes in the insert to help catch anything that misses the gap around th edrum. i will probably use a 4" pipe to my dc system  instead of the shop vac
 
...just one question, is that disk cleaner just a piece of rubber, if so, where would you get a hunk of it like that?
 
Lot of places like Rockler/woodcraft/etc carries that kind of abrasive sticks. Rockler has a sale on them right now. Not sure what the material is except its kind of rubbery.
 
Its actually pretty self explanatory video. Is that a Protool drill he uses with the right angle jig? Eric
 
ericbuggeln said:
Its actually pretty self explanatory video. Is that a Protool drill he uses with the right angle jig? Eric

It's a green Bosch drill he uses with the sanding disk gizmo. Bosch's hobbyist line, comparable to B&D. The drill in the drill stand is a Protool. The drill stand and sanding disk are made by Wolfcraft.

wolften said:
...just one question, is that disk cleaner just a piece of rubber,

Yep, it's a piece of rubber.

wolften said:
if so, where would you get a hunk of it like that?

Looking at your stated location, I can only get so specific as to say that you're in luck, you're on the right planet.
 
ericbuggeln said:
Its actually pretty self explanatory video. Is that a Protool drill he uses with the right angle jig? Eric
this video is but i was talking in general terms. some of his videos are complicated with no sound. its faily obvious whats going on in this vid. but i always get the feeling that i am missing a cool tip or trick he has come up with
 
Back
Top