Help with two deep sys port!

[johntarr]

Could use some help from anyone who has built a two deep sys port.

If you happen to have the dimensions & slides you used, I'd be super grateful.

I've checked this post and Richard/RMW made a nice template, but I must be missing something obvious, as I cannot get his measurements to add up to the overall drawer dimension he provides.

 

[gwendal]

I built a MFT3 cart with double sys port, the plans are on shaperhub, I attach the dimension of the shelf. To save space, I used a 1/2 core box bit to carve a handle under the shelf.

 

[johntarr]

[member=69258]gwendal[/member]  - This is super helpful, thank you! I loaded your model in Fusion 360, but I'm not sure how to show the dimensions as you did for the shelf. Is there an easy way to do that?

 

[gwendal]

To show dimension, select a part and go in drawing mode (Design -> Drawing -> From Design).
There, it is really fast to add dimensions. Since I only have the personal version, I cannot export the drawing to pdf, but for my use screenshots are good enough.

 

[johntarr]

[member=69258]gwendal[/member] - Thanks again. Hopefully one last question. Does this design allow both the front and back systainer to be opened without removing them from the shelf?

 

[gwendal]

[member=69258]gwendal[/member] - Thanks again. Hopefully one last question. Does this design allow both the front and back systainer to be opened without removing them from the shelf?

Yes, see the picture on the original thread. What matters is the length of the drawer slide (28'').

 

[mwolczko]

Sounds like you have what you need but I’m also happy to supply info about the one I built, described here:https://www.festoolownersgroup.com/...ake-on-systainer-storage/msg571916/#msg571916