DTR CUSTOMS
Member
- Joined
- Aug 16, 2015
- Messages
- 3
Hi,
Just recently purchased my Kapex, it was working great, I transported it to a job and back and now it's not cutting perfectly square on the upright 90 degrees?
It's clicking into the indent, so obviously should be a perfect 90, but when I check the cut with an engineers square it's slightly out.
Is this normal after transport? And how do I true it? And prevent it from happening?
Plz help
Just recently purchased my Kapex, it was working great, I transported it to a job and back and now it's not cutting perfectly square on the upright 90 degrees?
It's clicking into the indent, so obviously should be a perfect 90, but when I check the cut with an engineers square it's slightly out.
Is this normal after transport? And how do I true it? And prevent it from happening?
Plz help
