How to adjust New TSC55 to an Existing Guide Rail

[Keithptd@bellsouth.net]

Hello everyone.  Trust everyone is well.
Just purchased a new TSC55 and I am wanting to use the same rails as my TS 55 & TS 75 saws.
I was able to adjust the TS 75 to my existing rails of my TS55 (Concerning the plastic Strip)
However, these adjustment points are not available on the TSC55.
Has anyone found the procedure to set the TSC to existing rail?

Thank you in advance for the help.

 

[Rick Herrick]

This is a timely post.  I just picked up my new TSC55 the other day.  I had read about all the changes in the new version and I was very lucky to find out my new saw was actually the one that kept the riving knife.  I too had the worry about matching it for my TS55 and the 6 rails I had.  I went through the supplemental manual as there is a page near the end to walk you through.  One point it made is that newer versions only allow so much adjustment.  So I did a couple of quick tests on some scrap and it looks like my TSC is set the same as my TS.  I tried tests with 2 rails and I don't see any issue.  Hopefully you will see the same.

Page 22

 

[Keithptd@bellsouth.net]

Thank you very much. 
Will get in the shop and give this a whirl.