Cheese
Member
- Joined
- Jan 16, 2015
- Messages
- 12,532
Something else to think about is I do a lot of metal cutting. Sheets of metal tend to be smaller than sheets of ply, usually in the 2'-4' square range.
Last week I needed to cut a 1 3/4" wide strip off of some 5/16" aluminum. Rather than setting up the table, I just took one section of foam and laid it on the patio, made the cut and tossed the foam back into the garage.
Small pieces of foam or small pads are just easier to deal with.
Last week I needed to cut a 1 3/4" wide strip off of some 5/16" aluminum. Rather than setting up the table, I just took one section of foam and laid it on the patio, made the cut and tossed the foam back into the garage.
Small pieces of foam or small pads are just easier to deal with.