Is there a Festool part for connecting a CMS-GE to an MFT/3?

[RC]

I'm wondering that if I need more outfeed or width capacity for my CMS-GE base table, rather than putting money down on the extesion tables, could I use my MFT/3 as an extension table?

If doing this is an option could I use something similar to the MFT-to-MFT joining brackets to secure the CMS-table to the MFT?

 

[windmill man]

http://www.festool.co.uk/Products/Accessories/Pages/Detail.aspx?pid=484455&name=Sliding-table-and-fences-VS

This what you after [smile]

 

[AlexThePalex]

If you own both the CMS-GE and the MFT/3 you should know the dimensions are not the same. Only the height should be the same. Festool doesn't sell a special part to fit them together. All you could do is use the connector linked above on 1 side.

But it shouldn't be difficult to make your own interface.

 

[RC]

Well, I do own both but haven't had a warm enough day to have them both outside next to each other and they won't fit into my livingroom at the same time ;-)