Birdhunter
Member
- Joined
- Jun 16, 2012
- Messages
- 4,145
Used my new Kapex to cut the sides of a picture frame. Sides were 24" X 18" and 1 1/4" wide.
I taped the pieces to be cut together (long with long and short with short) so I'd be absolutely sure the lengths were identical. Mitered them at 45 degrees.
I laid the pieces out on my MFT using Qwas Dogs. The miters were perfect. Sides as narrow as 1 1/4" wouldn't show gaps as much as if they were much thicker, but my guess is that the Kapex angle is dead on.
I taped the pieces to be cut together (long with long and short with short) so I'd be absolutely sure the lengths were identical. Mitered them at 45 degrees.
I laid the pieces out on my MFT using Qwas Dogs. The miters were perfect. Sides as narrow as 1 1/4" wouldn't show gaps as much as if they were much thicker, but my guess is that the Kapex angle is dead on.
