Kapex on mft/3 kapex, height questions

[WarnerConstCo.]

I know all the combos of height that was designed into the kapex, sys 1's mft3/kapex and mft/3.

What about my CT.  I have the hose garage and was wondering if there was a certain size systainers I could stack on top of my CT
and have it be about the same height as my kapex on its mft/3.

I will go play stack the boxes now. [big grin]

 

[erikfsn]

Good question, I'm curious to hear what you find out.

 

[WarnerConstCo.]

Ok, I did some measuring.  Kapex on its mft/3 is 35 1/2", just like the mft/3.

My CT-22 with the hose garage and a sys 2 and sys3 are almost the same height as the bed of the saw.

Technically, the Saw is 3/8" of an inch taller.  Sorry, my metric tape is not at home with me.

I have plenty of scrap ply that size to make up the difference.  I could also make a bigger top to slide over the systainers on the CT.
It would give me a little more work surface.

The whole point behind this was, my CT is always there so why not slide it to the other end of the saw and put it to use as a portable out feed.