I redid my measurement on a flat table over the weekend and still have the same problem. I took the Kapex back to leevalley and exchanged for another unit. Did the same flatness test on the new Kapex table and it was flat across all miter angles. So, my first Kapex was definitely off.
I did some test cuts last night and noticed that i am not getting a complete through cut when cutting with a miter angle. See linked photo.
When i make a left 45 miter, the right piece of the cut leaves that little corner, but when i make a right 45 miter, the left piece leaves behind the little corner. At 90, it cuts through fine. I already tried lowering the blade depth a bit more with the adjusting the blade depth adjustment bolt. Am i missing something else?
https://www.dropbox.com/s/ekfmriwdih8l1fs/IMG_20140408_182239.jpg