Toolinator
Member
- Joined
- Dec 22, 2014
- Messages
- 48
When chopping shorter (but wide'ish) pieces of wood I noticed that the Kapex top surface (let's call it the table on the machine) seemed to be out flat and the boards would have tiny amounts of wobble.
I broke out the Starrett ruler, and sure enough one side of the table (opposite of fence side) is 0.015" out of flat. How in the world is this possible on a $1200 saw?!
Anyone else experience the same? I just sent a note to Festool, I'll wait to hear if this is 'acceptable' manufacturing tolerances or not. I sure hope it isn't.
I broke out the Starrett ruler, and sure enough one side of the table (opposite of fence side) is 0.015" out of flat. How in the world is this possible on a $1200 saw?!
Anyone else experience the same? I just sent a note to Festool, I'll wait to hear if this is 'acceptable' manufacturing tolerances or not. I sure hope it isn't.