Kapex UG Stand Mounting
- Thread starter fifo28
- Start date
Mine is out in the garage right now but I believe you use the innermost holes on both sides of the saw. Things wouldn't line up properly in any other orientation.
Sorry that I am not 100% sure but it's -40c here right now and I am not willing to run outside as the garage is detached.
Sorry that I am not 100% sure but it's -40c here right now and I am not willing to run outside as the garage is detached.
- Joined
- Nov 3, 2007
- Messages
- 5,133
As I recall, the Kapex has four specific mounting holes for the UG and hardware is provided to properly mount the saw to the UG.
Tom
Tom
Kevin Stricker
Member
- Joined
- Feb 6, 2009
- Messages
- 481
The one set is for mounting, the other holds the rubber feet that the saw sits on.
- Joined
- Nov 3, 2007
- Messages
- 5,133
You are correct, Kevin, that there are four to hold the rubber feet. The rubber feet are already mounted to the Kapex when it is shipped.
There is a 4 bolt-and-nut set that is shipped with the UG that hold the base of the Kapex to the UG. There are there are 2 UG mounts that bolt to the Kapex and 2 bolt/nut pairs for each of those mounts (8 pieces total - 4 bolts & 4 nuts). Once the 2 mounts are affixed to the Kapex, it can be mounted to the UG stand without tools, but rather, using the spin/flip mounts that are integral to the system.
Tom
There is a 4 bolt-and-nut set that is shipped with the UG that hold the base of the Kapex to the UG. There are there are 2 UG mounts that bolt to the Kapex and 2 bolt/nut pairs for each of those mounts (8 pieces total - 4 bolts & 4 nuts). Once the 2 mounts are affixed to the Kapex, it can be mounted to the UG stand without tools, but rather, using the spin/flip mounts that are integral to the system.
Tom
