Kapex video on YouTube!

[danrush]

Thanks, Eli.

I suspected that would be the review, I just wanted to hear it from someone who's actually used the machine on site. I agree that "fall-away" chips aren't the problem, it's the air born stuff. 

Thanks!!!  Dan

 

[Dan Uhlir]

I like it...does it go to eleven ?

          thanks Dan

 

[Eli]

In the sequel, the Kapex would go to 12. Laid most of the Valentine's Day oak floor today, back and knees intact so far. Probably finish tomorrow sometime and start the stairs. I've had an incredibly small amount of waste, and it's really been a pleasure. Cuts are still smooth as glass, lasers a treat, and more than once the crown stops were handy to hold a piece upright to notch. I think the only tool I like even close to as much as this is the Domino.

 

[FesGeek]

Duh uhhhh *drool* *drool*...someone get me a paper towel

I cannot wait to sell or give away my Delta compound saw!!!  Just the ease of adjusting every aspect of the saw is going to be a time saver...no more hauling out the allen wrench (unless you need swap blades of course).

hmmm...going to have to make a spot for the saw during my construction of my vehicle cabinet!!!

I got enough exclamation points in this post, you think I'm going to be standing in line for one?  Now it's time to budget in the money to be be able to get one the day they are here.

--Jason

 

[vkumar]

I thought the coolest part of the video was the fact that the table of the Kapex was the same height as a Systainer 1. Talk about a system!

I agree, I thought that was pretty cool along with the angle setter.

Vijay