I just finished my rolling lathe turning tools cabinet. Overall I'm quite happy with how it came out, it was my first complicated 32mm system project.
I got confused with mounting the drawers and the drawer faces which then caused problems with the door. The drawer boxes are a multiple of 32mm high. I wasn't sure where on the drawer box the slide was supposed to attach so I put it in the middle. The drawer fronts are also a multiple of 32mm high, but with the amount it reveal I left at the top and between then plus the thickness of the edge banding left me with space for the doors which was not a multiple of 32mm. I tried cutting the door to the height that fit and then referenced the 35mm holes in the doors from the bottom edge, but that left a larger than desired gap above the doors.
So if erock is listening I could really use at least another video on how to plan out the drawer boxes, drawer fronts, reveals, and allow for the thickness of the banding.
One general question I have is that if you cut all pieces to a multiple of 32mm you have to drill holes with the LR32 system before you put the edge banding on or the end stops won't fit. So unless you know for sure what the edge banding thickness is and allow for it during your cuts you're faced with drilling all holes before you put the banding on (domino holes get drilled after the banding), and then allow for the fact that everything is slightly over-sized. What's the "right" way to deal with all of this?
I got confused with mounting the drawers and the drawer faces which then caused problems with the door. The drawer boxes are a multiple of 32mm high. I wasn't sure where on the drawer box the slide was supposed to attach so I put it in the middle. The drawer fronts are also a multiple of 32mm high, but with the amount it reveal I left at the top and between then plus the thickness of the edge banding left me with space for the doors which was not a multiple of 32mm. I tried cutting the door to the height that fit and then referenced the 35mm holes in the doors from the bottom edge, but that left a larger than desired gap above the doors.
So if erock is listening I could really use at least another video on how to plan out the drawer boxes, drawer fronts, reveals, and allow for the thickness of the banding.
One general question I have is that if you cut all pieces to a multiple of 32mm you have to drill holes with the LR32 system before you put the edge banding on or the end stops won't fit. So unless you know for sure what the edge banding thickness is and allow for it during your cuts you're faced with drilling all holes before you put the banding on (domino holes get drilled after the banding), and then allow for the fact that everything is slightly over-sized. What's the "right" way to deal with all of this?