MFK 700 question

[Page]

Hello all,

I have a project that requires me to do some plastic laminate on some display cabinets. I have a question about on how I would be able to trim the laminate on angels (67.5). I've attached a photo with arrows pointing to where I'm describing. I currently have a PC trim router with adjustable base. Before I buy the MFK 700 will it be able to trim on angels or should I just use my PC with adjustable base.

Thanks,

 

[Warrior]

Will you be applying the laminate to the angled box after assembly? if so i think it would be OK. just keep in mind that the sensor bearing would be riding on its corner.

 

[Woodenfish]

You can get a 22.5? angled cutter that might help in some spots.

 

[Page]

Will you be applying the laminate to the angled box after assembly? if so i think it would be OK. just keep in mind that the sensor bearing would be riding on its corner.

Yes, I would laminate the top angled section first. I guess the side pieces, then the small top section and then the angled face of it.