MFT/3 and CMS Table Extensions

[Woodwork Wizard]

So are these dirt cheap CMS and MFT/3 extensions really that firm in use?

Well I can park three lorries on them...

 

[jonathan-m]

hahaha that made my day

 

[fritter63]

Of course, if I had a piece that needed in and out feeds like that, I'd probably just run the router on it freehand, rather than moving the piece itself.

 

[Stone Message]

Of course, if I had a piece that needed in and out feeds like that, I'd probably just run the router on it freehand, rather than moving the piece itself.

Not for doing the panel raising on those new 5.5m doors at Buckingham Palace though !

Peter

 

[Mr Heavy]

Of course, if I had a piece that needed in and out feeds like that, I'd probably just run the router on it freehand, rather than moving the piece itself.

Not for doing the panel raising on those new 5.5m doors at Buckingham Palace though !

Peter

Oh Kudos!!!!

 

[greg mann]

Nice example of upcycling with the ladders!

 

[Woodwork Wizard]

Of course, if I had a piece that needed in and out feeds like that, I'd probably just run the router on it freehand, rather than moving the piece itself.

But maybe not if the router bit was 50mm diameter...

I use this to remove 1 to 2mm from boards that I get cut slightly oversize from a sawmill, as the cut on their £10,000 table saw isn't that good.