MFT upgrade

[Allin]

Made a holder for the TSC55,any more updates to make?

 

[bertv]

Made a holder for the TSC55,any more updates to make?

Check Pinterest for more ideas…?

 

[Rick Herrick]

Made a holder for the TSC55,any more updates to make?

Where are the pictures?  [smile]

 

[Coen]

Made a holder for the TSC55,any more updates to make?

Sounds like a very bad idea  [unsure]

How do you turn it off?

 

[demographic]

Made a holder for the TSC55,any more updates to make?

Sounds like a very bad idea  [unsure]

How do you turn it off?

Just guessing but a no volt release switch system would likely do the trick.

 

[Peter_C]

Welcome to the FOG OP it would be good to put your country of origin as this is an international board.

Made a holder for the TSC55,any more updates to make?

By holder do you mean a shelf to store your saw on, attached to the MFT? Got a picture please?

A small storage tray might be nice for you. A 12"-14" (300mm) table extension on the off cut side is in my list of things to make. Already made a "wall" to stop the dust from shooting forward at the end of he cut (Blocks the end of the rail). Lots of folks build a shelf for under the MFT, which happens to do a great job of stiffening it up (Not so good if you work onsite and setup and take down often). If you do work onsite, wheels are great, or use a dolly. I would say use the MFT for awhile and make things as you see a need for them. Then make sure to post pictures so we can make our own if desired

 

[Imemiter]

I made a saw caddy for my holey table, though just afterward I saw a nicer design posted here. 

 

[Peter_C]

I made a saw caddy for my holey table, though just afterward I saw a nicer design posted here. 

Do you ever worry you might kick the hose and knock the saw off? I had a habit of setting my saw on my table and have caught the hose with my foot almost knocking it to the ground. That was when I decided to build a storage shelf.

 

[Imemiter]

I made a saw caddy for my holey table, though just afterward I saw a nicer design posted here. 

Do you ever worry you might kick the hose and knock the saw off? I had a habit of setting my saw on my table and have caught the hose with my foot almost knocking it to the ground. That was when I decided to build a storage shelf.

I haven't worried about that, but I might now!  [big grin]